X and Y ranges swapped for touch only

[samjcarroll01]

I have developed a UI in Squareline Studio that displays in landscape mode on a 4" ST7796 with XTP2046 with a resolution of 480x320. The rotation for the display is set to 3. I have gone through the calibration and test sketches for touch functionality. Since it is in landscape mode, I expect the range of X values to be 0-480 and the range of Y values to be 0-320. I have found that in the sketch exported from Squareline when I press on the lower right corner, it returns values of Data x 315 and Data y 476. If I press the top right corner, I get Data x 317 and Data y 20 values. This indicates that the X and Y ranges are swapped, and because of this, the coordinates for any presses are incorrect and do not trigger the correct functions on the UI. I have to press above and to the right of any widgets on the screen to trigger a press event on them. Since the UI is displaying properly on the screen, I cannot just change the rotation value in tft.setRotation(). Is there a way to swap the ranges for the X and Y axes for touch only?

Data x 0 - Top Left
Data y 1
Data x 0
Data y 0
Data x 1
Data y 0
Data x 1
Data y 0
Data x 307 - Top Right
Data y 33
Data x 303
Data y 33
Data x 308
Data y 31
Data x 309
Data y 32
Data x 306
Data y 31
Data x 305
Data y 34
Data x 303
Data y 33
Data x 305
Data y 29
Data x 307
Data x 319 - Bottom Right
Data y 468
Data x 319
Data y 476
Data x 316
Data y 474
Data x 314
Data y 476
Data x 316
Data y 466
Data x 316
Data y 474
Data x 0     - Bottom Left
Data y 478
Data x 0
Data y 474
Data x 1
Data y 476
Data x 1
Data y 474
Data x 1
Data y 471