Fail flash when use update_frm.sh

[crackerjacques]

Hello.
I am enjoying Tezuka Firmware forLibreSDR. Everything is currently working without a hitch when booted from SDCard.

However, if I send pluto.frm via SCP or other means and write it to the internal disk from update_frm.sh, it did not work.
Is it correct to say that this is not yet supported?

I also does not know how to write tezuka firmware to a blank SD card.

Best regards.

[F5OEO]

I didn"t try yet to write on flash of libresdr...As it is completely empty, you need to flash pluto.frm but also boot.frm. After that, you need to remove sd card.

[sq6emm]

I am unable to update boot.frm either from mounted storage nor cli...

# update_frm.sh ./pluto.frm 
423+1 records in
423+1 records out
Done
# 
# update_frm.sh ./boot.frm 
Failed

I also remember that originally during the flash process LED1 or sth was blinking... now during the flash no LED is blinking (but it still takes few minutes)

[F5OEO]

Until I add update_boot.sh , it is not possible to write boot.frm on flash except by using usb (put boot.frm in virtual file mounted, then eject).

[crackerjacques]

Thank you very much.
I am so supportive I want to buy you a coffee. I can only offer you virtual coffee now, but I support you.☕☕☕