Connect to new WIFI #462
-
Hi I built some screens for my Sunton E3248S035C and noticed that when I went on holidays for my beach house I had to reconnect it to a new WIFI. |
Beta Was this translation helpful? Give feedback.
Replies: 3 comments 18 replies
-
Either reflash are use the serial console. There are dozens of good serial apps, or use the Chrome or Edge web browser. You can also configure the wifi settings via the serial or telnet console:
|
Beta Was this translation helpful? Give feedback.
-
Hello, stepping into this discussion, i would like to change wifi settings (on a Lanbon board) without connecting to a serial connection. Isn't there a way to force the board into the AP mode (like on the first startup), maybe when the given ssid is not found after a (re)boot? Or perhaps by a pushbutton on a settings-page (on the screen in offline-mode)? Greetz, Dirk |
Beta Was this translation helpful? Give feedback.
-
Thanks for this thread, I added this button in my pages.jsonl, it delete current Wifi setting, restart the screen, and show the wifi configuration page on new launch :)
|
Beta Was this translation helpful? Give feedback.
You can use any serial terminal application to connect to the serial port and use it as a terminal.
Just select the correct COM port and set the speed to 115200 e.g. in PuTTY:
Then type the commands above.