diff --git a/content/manual/neon-oblique/index.md b/content/manual/neon-oblique/index.md
index c92d937..f71de7b 100644
--- a/content/manual/neon-oblique/index.md
+++ b/content/manual/neon-oblique/index.md
@@ -6,6 +6,7 @@ weight: 14
 
 - [Overview](#overview)
   - [MOAR COWBELL!](#moar-cowbell)
+  - [Little Pig](#little-pig)
 
 ## Overview
 
@@ -31,3 +32,32 @@ the bottom of the module which should reset the audio buffer if required.
 
 All the CV inputs are calibrated to +-5volts and are added to the knob value, the result is clamped
 to the knob extents.
+
+### Little Pig
+
+This module is an experimental feedback distortion.
+
+![Little Pig](https://library.vcvrack.com/screenshots/200/DanTModules/LittlePig.png)
+
+The controls are as follows (left to right, top to bottom):
+
+* `Snuffle` - Input signals are amplified, this acts like a compressor/limiter for the input
+* `Grunt` - This is the amount of distortion applied to the input signal
+* `Snort` - This is basically a gain/volume for the distorted signal part of the output
+* `Snout` - This is a mix/volume for the feedback, at minimum there won’t be much feedback, at
+  maximum you will likely get a massive howl
+* `Squeal` - This is the target feedback frequency, the input is volt/octave, it really depends on
+  the input signal as to what effect this has, sometimes it can enhance the frequency, sometimes it
+  can act like a filter
+* `Pig Power!` - This is just an active switch to turn the distortion & feedback on and off
+* `Clean Filth` - This button resets the internal buffers, this can be useful if you have pushed the
+  feedback too far and have blown out the audio channels (ie. the module has stopped processing the
+  input signal)
+* `Audio input` yellow port - this is the signal input
+* `Oink!` magenta port - this is the distorted signal + feedback output
+* `Neat Trotters` switch & LED - This is basically a clip feature that will limit the output to
+  10volts peak to peak, the LED will be red when clipping is happening, note that when on, this is
+  still applied even when distortion and feedback are not active
+
+All the CV inputs are calibrated to +-5volts and are added to the knob value, the result is clamped
+to the knob extents.