pins used for LEDs on nice!nano

[mruros]

Hi,

I've recently purchased the (pre-soldered) kit from you, and it's arrived a few days ago.
It is beautiful. I've honestly never had such a customized typing experience, and I feel this specific design has turned out wonderfully.

I've since reflashed the firwmare with my wanted keymap, but i'm having some trouble figuring out how the per key LEDs are set up and connected, and to which pins on the nice!nano v2 controllers they are connected.

I've also not found definitions for the LEDs on zmk as a compatible hardware part, so I'm probably looking at defining the boilerplate myself.

Any information you could offer on the topic would be of much help!
Thanks!

[TweetyDaBird]

Hi,

I've recently purchased the (pre-soldered) kit from you, and it's arrived a few days ago.

It is beautiful. I've honestly never had such a customized typing experience, and I feel this specific design has turned out wonderfully.

I've since reflashed the firwmare with my wanted keymap, but i'm having some trouble figuring out how the per key LEDs are set up and connected, and to which pins on the nice!nano v2 controllers they are connected.

I've also not found definitions for the LEDs on zmk as a compatible hardware part, so I'm probably looking at defining the boilerplate myself.

Any information you could offer on the topic would be of much help!

Thanks!

Thank you for the praise, I'm just happy somebody likes my design!

As said before, my experience with ZMK is more limited. (I keep selling the n!n before I can take my time and play with them!)

AFAIK nobody has setup (or shared) a setup with per key RGB, so you are probably starting from an example or by looking at other keyboards for the examples. The pin connected for RGB data is D3 (or TX1) on a ProMicro and it should be named the same on n!n.

Really, the RGB as such is compatible with ZMK, so you should in principle define the pin, and the amount of RGB (29 per hand) and that should be it, besides if you need to represent the physical layout. (Like I said, I haven't done it yet myself).

[mruros]

That's exactly what I was looking for. Will update if i run into any board-related issues, but for now, this has been a dream come true.
I'll be uploading some photos as soon as I get a hold of an encoder knob, as it really came out beautifully!