Hardware before release was tested?? Ethernet PHY is not connected correctly and the slave mc33775a card is not working in default assembly.

[BhavaySen]

The data lines for PHY is connected incorrectly i.e. In mirrored manner.

Slave mc33775a is not working in default assembly. Designers of the board calculated the total load requirements from the external series pass regulator??

I have an question, whether the hardware designs are tested before release or not??

@foxBMS
#47 #44

[foxBMS]

Dear @BhavaySen,

please open specific issues for each topic and do not mix different items as this makes tracking issues more complex than needed (e.g., supported AFEs and PHYs are different topics).

• BMS-Slave: The MC33775A-based foxBMS BMS-Slave v1.0.0 is working in the default configuration and we cannot reproduce any issue with that hard- or software. If there is an issue with that BMS-Slave please add debug information in Slave card MC33775A #44.
• BMS-Master: Thanks for raising the PHY-issue. We will create a specific issue for that bug.

Best regards,
The foxBMS Team