forked from homework/openvswitch
-
Notifications
You must be signed in to change notification settings - Fork 0
/
INSTALL.userspace
53 lines (40 loc) · 2.01 KB
/
INSTALL.userspace
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
19
20
21
22
23
24
25
26
27
28
29
30
31
32
33
34
35
36
37
38
39
40
41
42
43
44
45
46
47
48
49
50
51
52
53
Using Open vSwitch without kernel support
=========================================
Open vSwitch can operate, at a cost in performance, entirely in
userspace, without assistance from a kernel module. This file
explains how to install Open vSwitch in such a mode.
The userspace-only mode of Open vSwitch is considered experimental.
It has not been thoroughly tested.
This version of Open vSwitch should be built manually with "configure"
and "make". Debian packaging for Open vSwitch is also included, but
it has not been recently tested, and so Debian packages are not a
recommended way to use this version of Open vSwitch.
Building and Installing
-----------------------
The requirements and procedure for building, installing, and
configuring Open vSwitch are the same as those given in INSTALL.Linux.
You may omit configuring, building, and installing the kernel module,
and the related requirements.
On Linux, the userspace switch additionally requires the kernel
TUN/TAP driver to be available, either built into the kernel or loaded
as a module. If you are not sure, check for a directory named
/sys/class/misc/tun. If it does not exist, then attempt to load the
module with "modprobe tun".
The tun device must also exist as /dev/net/tun. If it does not exist,
then create /dev/net (if necessary) with "mkdir /dev/net", then create
/dev/net/tun with "mknod /dev/net/tun c 10 200".
Using the Userspace Datapath with ovs-vswitchd
----------------------------------------------
To use ovs-vswitchd in userspace mode, create a bridge with datapath_type
"netdev" in the configuration database. For example:
ovs-vsctl add-br br0
ovs-vsctl set bridge br0 datapath_type=netdev
ovs-vsctl add-port br0 eth0
ovs-vsctl add-port br0 eth1
ovs-vsctl add-port br0 eth2
ovs-vswitchd will create a TAP device as the bridge's local interface,
named the same as the bridge, as well as for each configured internal
interface.
Bug Reporting
-------------
Please report problems to [email protected].