Is it possible to use two devices (mbus & Wmbus)?

[Psicrow925]

Hello
I would like to read two meters.

One via mbus and one via wmbus.

But if I specify two devices on the config page, after saving and restarting, one seems to be ignored or overwritten and I get no telegrams from both?

I use Home Assistant.

[weetmuts]

Can you post your configuration here? It should be possible to read both mbus and wmbus.

From the readme, you have give the mbus a name if you have multiple buses, eg from a config:
device=MAIN=/dev/ttyUSB0:mbus:2400
device=RADIOMAIN=/dev/ttyUSB1:im871a:c2

And then the mbus meter has to have its pollinterval set.
pollinterval=60s

And the mbus driver must look like:
driver=themeterdriver:MAIN:mbus

Otherwise wmbusmeters does not know which device to send the poll request to.

[Psicrow925]

Thank you for your reply.

I will try it out this evening.

[Psicrow925]

Hello

Unfortunately I have the same result as yesterday. a device is deleted after saving and reloading.

After saving and reloading, it will look like this.

if i configure mbus individually, everything works and i get values.
the same applies if i configure wmbus individually, then i receive the encrypted telegrams.

but both devices cannot be configured

[Psicrow925]

I have found the answer here
2 Devices Configuration Home Assistant

This works for me