You signed in with another tab or window. Reload to refresh your session.You signed out in another tab or window. Reload to refresh your session.You switched accounts on another tab or window. Reload to refresh your session.Dismiss alert
If you use the G92 Z1.2 for instance to adjust the offset of your bed, the status bar display Printing ... ETA HH:MM:SSs Layer 0/XXX while the layer number multiplied by the layer height is inferior to the value specified with G92.
Also the layers appears under the displayed grid, and I think it should not as it is just an offset set in order to correct a miss calibrated Z-probe.
The text was updated successfully, but these errors were encountered:
If you use the G92 Z1.2 for instance to adjust the offset of your bed, the status bar display Printing ... ETA HH:MM:SSs Layer 0/XXX while the layer number multiplied by the layer height is inferior to the value specified with G92.
Also the layers appears under the displayed grid, and I think it should not as it is just an offset set in order to correct a miss calibrated Z-probe.
The text was updated successfully, but these errors were encountered: