Skip to content

r48xxgx-can-web.factory.bin
Compare
Choose a tag to compare
@mjpalmowski mjpalmowski released this 16 Dec 17:07
· 68 commits to main since this release
v0.9.4
2f2f7c5
This commit was created on GitHub.com and signed with GitHub’s verified signature.
GPG key ID: B5690EEEBB952194
Verified
Learn about vigilant mode.

This is a Web surface to control R48xxGx modules via CAN BUS. It does not do MQTT or Homeassistant. (if you want that please compile your own from the published YAML examples)

New in this release:
Dropdown select model:
R4875G
R4850G
R4830G

Just download the .bin file (r48xxgx-can-web.factory.bin) and upload it to an ESP32 WROOM32 dev board using this link:
https://web.esphome.io/

Make sure you have the following connected:

tx_pin: GPIO19==tx of the CAN tranceiver board
rx_pin: GPIO21==rx of the CAN tranceiver board

Once the firmware is on the ESP32, it will reboot and after 3 minutes it will
create a hotspot, now connect your PC/Phone to the hotspot "R4875G1 Fallback Hotspot"
12345678
once connected to the hotspot open your browser and go to
192.168.4.1
enter you wifi credentials, the esp reboots, the hotspot dissapears and stays gone if it can connect to your wifi, now you can find the web interface at:
http://r48xxgx-can-web.local/
connect the CAN-H to CAN-H and CAN-L to CAN-L , plug in your R48xxGx rectifier and happy charging :)

For this release also make sure pins 9 and 10 are connected to each other on the board edge of the R4875G1, if they are open use R4850G2 profile.

Assets 3
Loading