Skip to content

r48xxgx-can-web.factory095.bin
Compare
Choose a tag to compare
@mjpalmowski mjpalmowski released this 01 Jan 22:58
· 40 commits to main since this release
v0.95
9fc1b9c
This commit was created on GitHub.com and signed with GitHub’s verified signature.
GPG key ID: B5690EEEBB952194
Verified
Learn about vigilant mode.

This is a Web surface to control R48xxxx modules via CAN BUS. It does not do MQTT or Homeassistant. (if you want that please compile your own from the published YAML examples)

New in this release:
"One Click" SETUP button

Just download the .bin file r48xxgx-can-web.factory095.bin and upload it to an ESP32 WROOM32 dev board using this link:
https://web.esphome.io/

Make sure you have the following connected:

tx_pin: GPIO19==tx of the CAN tranceiver board
rx_pin: GPIO21==rx of the CAN tranceiver board

Once the firmware is on the ESP32, it will reboot and after 3 minutes it will
create a hotspot, now connect your PC/Phone to the hotspot "R4875G1 Fallback Hotspot"
12345678
once connected to the hotspot open your browser and go to
192.168.4.1
enter you wifi credentials, the esp reboots, the hotspot dissapears and stays gone if it can connect to your wifi, now you can find the web interface at:
http://r48xxgx-can-web.local/
connect the CAN-H to CAN-H and CAN-L to CAN-L , plug in your R48xxGx rectifier and happy charging :)

This release should be compatible with most Huawei R48xxxxx rectifier boards, it supports a single board.

Assets 3
Loading