Skip to content

appendix assembly variations

Jump to bottom
Rodrigo Freire edited this page Mar 1, 2020 · 6 revisions

Where to lodge / mount / assemble it?

While the primary project aim was to integrate the SDR seamlessly inside the radio, there are some other assembly variations that might suit better your milleage. In order of simplicity, those are the options:

1. Panadapter on the radio, SDR in the outside

FT-991/A with external FI port

FT-991/A with external FI port

This is by far the simplest and least intrusive design. Actually, this was my first implementation to assure that everything was indeed working. All it takes is unplugging a U.FL. connector and tapping 13.8V from the radio.

Pros:

  • You have the ability to deploy any SDR better than the RTL-SDR to your radio
  • Very simple and minimum modification and effort required.
  • Works nicely as a proof of concept and for wetting your toes in the project.

Cons:

  • Extra cable coming out of the radio
  • Ground loop risk
  • Risk introducing external signal in your radio receive chain
  • The cable might radiate RF inside the radio (*)
  • Needs choking in the FI cable (*)

(*) - These can be mitigated if you attach an SMA flange connector to your radio chassis

2. Panadapter and SDR in the radio, external USB connection

FT-991/A with internal SDR, external USB cable (click here)

In this scenario, the panadapter and the SDR are lodged inside the radio - the only cable coming out of the radio is the USB cable that you will connect to your computer. The FI signal is contained inside the radio and not subjected to introducing noise to your radio RX block.

Pros:

  • Pretty simple to deploy though requires some extra care when deploying the SDR inside the radio
  • IF signal contained inside the radio, without external disturbances

Cons:

  • External cable coming out of the radio
  • Needs choking on the USB cable - otherwise the SDR goes out when you TX
  • Ground loop risk

3. Panadapter and SDR in the radio, internal USB connection

FT-991/A, internal panadapter and SDR, no external wires

This is when things gets an order of magnitude more complex. This requires the replacement of the radio's USB hub, a super picky QFN solder - but by far with the most rewarding results.

Pros:

  • Clean setup, no external cables coming out of the radio
  • No risk inserting external noise into the radio

Cons:

  • Way more complex: Requires replacing a Main Unit QFN IC (Which can be done easily (less than 5 minutes) by your local radio repair expert, though).
Clone this wiki locally